Who installs air conditioning in Vancouver, WA
777 HVAC installs central air conditioning, adds cooling to existing furnaces and replaces worn-out air conditioners for homes in Vancouver and nearby Clark County. Alex, the owner, runs the load calculation, writes the quote and does the installation. Estimates are free.
Build a cooling plan around the house
Good cooling design considers more than floor area. Windows, sun exposure, insulation, air leakage and room layout all change how much cooling a house needs.
Clark County’s building department warns that cooling systems sized without the required calculation are often 143% to 322% oversized (Clark County HVAC System Guidelines). An oversized air conditioner cycles on and off, leaves the house clammy and still misses the warm rooms. Rooms that are always warm should be part of the conversation from the start.
Adding air conditioning to an existing furnace
Most forced-air homes can add central air. The work usually involves:
- a cooling coil on the furnace, matched to the outdoor unit;
- refrigerant lines from the coil to the outdoor unit;
- a pad or stand for the outdoor unit with proper clearances;
- a dedicated electrical circuit and disconnect;
- a condensate drain for the water the coil removes.
The furnace blower and the ducts have to move enough air for cooling, so both are checked before you are quoted.
Air conditioner or heat pump?
An air conditioner only cools. A heat pump cools the same way and also heats, so it can take over most of the work your furnace does now. The better fit depends on your current heating, your priorities and the budget, and you can have both priced side by side.
What affects the price
- The size and efficiency of the equipment.
- Whether the furnace blower and ducts can handle cooling as they are.
- Electrical work: panel space and the new circuit.
- The line-set route and where the outdoor unit goes.
- Permit and inspection fees.
Permits and inspections
Replacing or adding heating and cooling equipment needs a mechanical permit and an inspection. The details depend on where the house is:
- City of Vancouver: when a furnace or air conditioner is added or replaced, the ducts have to be leak-tested and the test affidavit sent to the city before final approval (City of Vancouver).
- Unincorporated Clark County (Hazel Dell, Salmon Creek, Orchards and other areas outside city limits): a one-for-one swap of a furnace, heat pump or air conditioner can use the county’s Limited Trade Permit, which only licensed contractors can buy and which always includes at least one inspection (Clark County).
- Battle Ground, Camas, Ridgefield and Washougal each issue their own permits through their own building departments.
Ask any installer, including us, for the permit number before the work starts.
Installation and handover
After installation, start-up checks and a controls walkthrough show you how the new system works. Keep the equipment documentation, and review filter care and seasonal maintenance before the first busy cooling season.
“This company did great work on my air conditioning installation and I’m very thrilled to have my house cool.”
Common questions
Can AC be added to my existing furnace?
Often it can, if the furnace blower, the space for a coil, the ducts and the electrical system are suitable. Compatibility and any upgrades are checked on site.
Will a larger air conditioner cool better?
No. Correct sizing and airflow matter more than extra capacity. An oversized unit cycles too often and leaves humidity and hot rooms behind.
Should I get an air conditioner or a heat pump?
If you only want cooling, an air conditioner is simpler. A heat pump also heats, which can cut how much your furnace runs. Ask for both to be priced so you can compare.
What does an estimate include?
A written scope naming the equipment, the installation labor and any electrical, duct or drainage work, plus what is excluded and the expected timing.